World Trade Center Tower Steel Sample Shows Severe Damage Due To A High Temperature Corrosion Attack Which Melted The Steel

From 911Encyclopedia
Jump to: navigation, search

World Trade Center 7 Steel Samples Show Severe Damage Due To A High Temperature Corrosion Attack Which Melted The Steel

NIST Claims Molten Steel In The Wreckage Was Due To Long Term Combustion Within The Debris Pile

World Trade Center Hot Spots


Several samples from Buildings 7, and 1 or 2 of the World Trade Center were collected during the FEMA forensic investigation shortly after September 11, 2001. Macroscopically these samples revealed severe “erosion” of the steel beam thickness from 1/2 inch to total metal loss in some regions, as well as localized plastic deformation. We were asked to determine the cause of this “erosion” as well as the temperature that the steel experienced. wpi.edu


A microstructural analysis of these steel samples has been completed. In Building 7, the structural steel was A36. Figure 2 shows the near surface microstructural changes that occurred in the steel. The as-fabricated microstructure consisted of a hot worked banded structure of ferrite and pearlite. In severely “eroded” regions where the thickness had been reduced to less than a 1/16 of and inch significant decarburation was observed. In addition, some pearlite bands presented regions that had re-austentized as well as regions where the pearlite had started to spheroidize. These observations indicate that steel had experienced temperature between 550 and 850°C. An examination of the “slag” that formed on the surface of the steel found iron oxides and iron sulfides. It appeared that the “slag” was liquid at high temperature and easily attacked the grain boundaries. A eutectic microstructure was seen within the “slag” of iron oxides and iron sulfides. If these compounds were pure Wustite (FeO) and Iron sulfide (FeS), the eutectic temperature is 940°C. wpi.edu


It appears that the severe “erosion” was due to the sulfidation and oxidation (i.e. hot corrosion) of the steel followed by the liquid “slag” attack of the grain boundaries. A sample from either Building 1 or 2 presented similar macroscopic observations. In these buildings, the steel was a High Strength Low Alloy Steel (HSLA). The microstructure revealed somewhat different phase distributions. This steel contained less carbon and an alloy addition of copper. The “slag” while comprised of both iron oxides and iron sulfides presented a significantly different microstructure near the surface as shown in Figure 3. wpi.edu


Evidence of grain boundary attack by sulfidation is clearly visible. A gradient in sulfur concentration inward from the surface is shown in Figure 4. The internal sulfides appeared to interact with the penetration of this liquid “slag.” wpi.edu


IMSBiedermanA2.pdf_Figure_3.png

FIG. 3. Surface reaction region in WTC 1 or 2 column member.

IMSBiedermanA2.pdf_Figure_4.png

FIG. 4. Hot Corrosion in WTC 1 or 2 steel.

Personal tools
Namespaces

Variants
Actions
Navigation
Toolbox